Artificial Lawn Installation Guide
Equipment needed for your Artificial Lawn Installation: spade, turf cutter, hand roller or vibrating plate, wheel barrow, a sharp Stanley knife, large pair of sharp scissors, stiff brush, hammer, pegs, geo-textile, rake.
Ground Preparation for Artificial Grass
Remove all vegetation and rocks, down to the bare earth using a turf cutter or spade.
During dry conditions wet the sub base a day before the installation.
Peg a geo-textile weed barrier to the base.
In some certain circumstances you may need to use the wooden border.
Installation of Artificial Grass on Gardens
Cut carefully in the backing of the artificial grass and trim.
Fix with adhesive or stainless screws on wooden beams (treated to prevent moisture) or with stainless nails in the sub base.
Brush in sand (depending on grass product). Sweep dry kiln sand into the pile after laying the grass to weigh the grass down and stand the grass pile up.
Seaming Tape – Adhesive (if joining)
Adjacent rolls should be laid together ensuring that straight cut edges can be butted close together.
Butt both surfaces together, ensuring the pile is running in the same direction.
The seaming tape is used to put the rolls together. Unroll the seaming tape along the seam line, ensuring equal tape laid centrally along the seam.
Apply the adhesive with a spatula or glue cartridge gun to the top surface of the seaming tape.
Installation of Artificial Grass on Existing Hard Surfaces
Remove surface imperfections.
Thoroughly clean to remove all dirt, paint, grease that will prevent good adhesion.
Rolls can be loose laid or fixed with a spots of outdoor adhesive or with double-sided adhesive tape.
Brush the piles once installed.
Depending on grass product sweep dry kiln sand into the pile after laying the grass to weigh the grass down and stand the grass pile up.